JUKI’s Presser Foot with Guide, part 40080952, has marks along the right side of the foot. The manufacturer describes them as guides for parallel straight or decorative stitching. The marks are spaced 2 mm apart and extend from 0 to 2 cm from the center of the needle opening; they describe guide positions, not a machine’s maximum stitch width.
Models listed by JUKI#
The JUKI household-accessory page checked on 2026-09-26 lists part 40080952 for these models:
| Listed HZL models | Listed DX models |
|---|---|
| HZL-UX8S, HZL-UX8, HZL-NX7, HZL-DX7, HZL-DX5, HZL-F600, HZL-F400, HZL-F300, HZL-G320, HZL-G220, HZL-G120, HZL-G210, HZL-G110 | DX-2000QVP, DX-4000QVP, DX-3000QVP |
This is the model list displayed for this part on that JUKI page, not a complete JUKI accessory catalog or a claim about unlisted regional variants. Match the complete model name and revision before ordering.
Use the markings as a guide#
Choose a mark as a spacing reference for the next straight or decorative line, then keep the fabric edge aligned to that guide as you sew. The product page describes the marks’ spacing and use; it does not specify a seam-width setting, stitch restrictions, or a guaranteed result for a particular fabric or task.
Verify the exact setup#
The listing does not provide a full installation or needle-clearance procedure, and it does not state regional availability. Check the current local JUKI listing and your exact machine manual for the part, selected stitch, attachment, and clearance. Turn the handwheel by hand with the machine off where the manual directs, and stop if the needle contacts the foot or plate.
For a model-first fit process, see the presser-foot compatibility checklist. JUKI’s separate smooth-foot parts for difficult-to-feed material are covered in the roller and smooth-foot comparison.